Home › Engine / Hybrid System › 1NZ-FXE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE ENGINE UNDER COVER RH


3. SEPARATE NO. 2 ENGINE ROOM RELAY BLOCK AND NO. 2 JUNCTION BLOCK ASSEMBLY


    A268172
  1. Remove the bolt and 2 nuts, and separate the No. 2 engine room relay block and No. 2 junction block assembly.



4. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH


    A266935
  1. Place a jack underneath the engine, then put a wooden block on the jack.
    Text in Illustration 
    V100145
    Jack Position

    NOTICE:
    To prevent the No. 2 oil pan from deforming, do not place any attachments onto the No. 2 oil pan.



    A266934
  1. Remove the 4 bolts, 2 nuts and engine mounting insulator sub-assembly RH.



5. REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY


    A266936E01
  1. Using SST, hold the crankshaft damper sub-assembly in place and loosen the bolt.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    SST
    09213-58012   (91111-50845)
    09330-00021  

    NOTICE:
    When installing SST, be careful that the bolt which holds SST does not interfere with the timing chain cover.



    A266938E01
  1. Using SST, remove the crankshaft damper sub-assembly and bolt.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    HINT:
    Apply a lubricant to the threads and end of SST.



6. REMOVE OIL PUMP SEAL


    A266939E01
  1. Using a knife, cut off the lip of the oil pump seal.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Cut Position

  1. Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or the crankshaft.

    HINT:
    1. Wrap the screwdriver tip with protective tape before use.
    2. After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.