Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


2. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A267686
  1. Remove the 4 bolts and 4 compression springs.

  1. Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.



3. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR SUB-ASSEMBLY


    C251099
  1. Remove the nut and 2 bolts and front No. 1 floor heat insulator sub-assembly.



4. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C249908
  1. Disconnect the cable end from the shift lever assembly.



    C249910E01
  1. Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut, disconnect the transmission control cable assembly from the shift lever plate.
    Text in Illustration 
    *1
    Nut
    *a
    Rotate Approximately 180°
    *b
    Disconnect

    NOTICE:
    Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



    C249710E01
  1. Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
    Text in Illustration 
    *1
    Transmission Control Cable Clamp
    *2
    Transmission Control Cable Support

  1. Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.

  1. Separate the transmission control cable assembly from the transmission control cable clamp and transmission control cable support.



    C261399
  1. Remove the 3 nuts and then remove the transmission control cable assembly from the vehicle exterior.



5. REMOVE NO. 2 TRANSMISSION CONTROL CABLE CLAMP

HINT:
Perform this procedure only when replacement of the No. 2 transmission control cable clamp is necessary.



    C251101
  1. Remove the nut and No. 2 transmission control cable clamp from the body.