Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    C256888E01
  1. Using a screwdriver with its tip wrapped with vinyl tape, remove the set ring and cylinder boot from the disc brake cylinder.
    Text in Illustration 
    *1
    Vinyl Tape

    NOTICE:
    Be careful not to damage the brake piston or cylinder.



2. REMOVE FRONT DISC BRAKE PISTON


    C250556
  1. Place a piece of cloth between the front disc brake piston and disc brake cylinder.

  1. Apply compressed air to remove the front disc brake piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not allow any brake fluid to spatter.



3. REMOVE PISTON SEAL


    C256892E01
  1. Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the disc brake cylinder.
    Text in Illustration 
    *1
    Vinyl Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG