Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > REASSEMBLY

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

HINT:
Fully tighten the front disc brake bleeder plug after bleeding any air left in the system.



2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP


3. INSTALL PISTON SEAL


    C211755
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
    Text in Illustration 
    V100155
    Lithium Soap Base Glycol Grease

  1. Install the piston seal to the disc brake cylinder.

    NOTICE:
    Securely install the piston seal into the groove of the disc brake cylinder.



4. INSTALL FRONT DISC BRAKE PISTON


    C256889E01
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
    Text in Illustration 
    *1
    Cylinder Boot
    *2
    Front Disc Brake Piston
    V100155
    Lithium Soap Base Glycol Grease

  1. Install the cylinder boot to the front disc brake piston.

  1. Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston, and install it to the disc brake cylinder.

    NOTICE:
    Do not install the piston forcibly in the disc brake cylinder.



5. INSTALL CYLINDER BOOT


    C256890E01
  1. Install the cylinder boot to the disc brake cylinder.
    Text in Illustration 
    *1
    Set Ring
    *2
    Cylinder Boot

    NOTICE:
    Securely install the cylinder boot to the groove of the disc brake cylinder and front disc brake piston.

  1. Install a new set ring.

    NOTICE:
    1. Securely install the set ring to the outer groove of the cylinder boot.
    2. Do not damage the cylinder boot.