Home › Vehicle Exterior › DOOR / HATCH › FRONT DOOR

FRONT DOOR > ADJUSTMENT

for Preparation Click here


B211130E08

HINT:
Text in Illustration 
*1
Centering Bolt
*2
Standard Bolt
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.
  3. Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
  4. Specified torque for standard bolts is shown in the standard bolt chart (Click here)



1. INSPECT FRONT DOOR


  1. Check that the clearance measurements of areas "a" through "i" are within each standard range.


    B301507E03


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    a
    2.7 to 5.7 mm (0.106 to 0.224 in.)
    b
    1.9 to 4.9 mm (0.0748 to 0.193 in.)
    c
    3.2 to 6.2 mm (0.126 to 0.244 in.)
    d
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    e
    3.2 to 6.2 mm (0.126 to 0.244 in.)
    f
    3.2 to 6.2 mm (0.126 to 0.244 in.)
    g
    4.2 to 7.2 mm (0.165 to 0.283 in.)
    h
    4.2 to 7.2 mm (0.165 to 0.283 in.)
    i
    3.2 to 6.2 mm (0.126 to 0.244 in.)
    -
    -



2. ADJUST FRONT DOOR

NOTICE:
Make sure to turn the power switch off when adjusting door lock strikers.



    B297607
  1. Using SST, loosen the hinge bolts on the vehicle body and adjust the door position.

    SST
    09812-00010  

  1. Tighten the body side hinge bolts after the adjustment.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }

  1. Tighten the door side hinge bolts after the adjustment.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }



    B297608
  1. Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.

  1. Using a brass bar and a hammer, hit the striker to adjust its position.

  1. Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }