SFI SYSTEM > DIAGNOSIS SYSTEM |
| EURO-OBD (EUROPEAN SPEC.) |
![]() |
| M-OBD (EXCEPT EUROPEAN SPEC.) |
![]() |
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
| DLC3 (Data Link Connector 3) |
Check the DLC3 (Click here).
| FREEZE FRAME DATA |
| AUXILIARY BATTERY VOLTAGE |
| MIL (Malfunction Indicator Lamp) |
The MIL is illuminated when the power switch is turned on (IG).
The MIL turns off when the power switch on (READY). If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.
| ALL READINESS |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Turn the power switch off and wait for at least 30 seconds.
Turn the power switch on (IG) and turn the tester on.
Perform the DTC judgment driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input the DTCs to be confirmed.
Check the DTC judgment result.
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|