Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected:

System
See Procedure
Power Door Lock Control System
Click here


2.PRECAUTION OF WASHER NOZZLE ADJUSTMENT
  1. Do not clean or adjust the washer nozzle with a safety pin, etc. because:

    1. The washer nozzle tip is made of resin and could be damaged.

    2. Adjustment is not necessary for this spray type washer nozzle (for Front Side). If it is necessary to change the nozzle angle, replace the washer nozzle (for Front Side) with one that has a different nozzle angle.

  2. If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.