ENGINE IMMOBILISER SYSTEM > PRECAUTION |
| 1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| System Name | See Procedure |
| Power Door Lock Control System |
Click here
|
| 2.PRECAUTIONS WHEN USING INTELLIGENT TESTER |
When using the intelligent tester with the power switch off to troubleshoot: Connect the intelligent tester to the DLC3, and turn a courtesy light switch on and off at 1.5 second or less intervals until communication between the intelligent tester and vehicle begins.
| 3.PRECAUTION FOR REGISTRATION |
If replacing any of the following parts, refer to Service Bulletin.
Certification ECU (smart key ECU assembly)
ID code box (immobiliser code ECU)
Steering lock ECU (steering lock actuator assembly)
Hybrid vehicle control ECU
Electrical key transmitter sub-assembly
After replacing the steering lock ECU (steering lock actuator assembly), confirm the lock/unlock operation of the steering lock.
| Steering Lock | Operation |
| Locks | With the power switch off, open and close any door. |
| Unlocks | Turn the power switch from off to on (ACC) or on (IG). |
| 4.PRECAUTIONS FOR AUXILIARY BATTERY |
Immediately after disconnecting and reconnecting the auxiliary battery cable, the entry unlock function may not operate. If this occurs, the entry unlock function can be restored by performing a wireless door lock and unlock operation, or key-linked door lock and unlock operation.
When the auxiliary battery is discharged, if the auxiliary battery of another vehicle is used to jump start the hybrid control system, move the shift lever to P and open and close the driver door with the power switch off before starting the hybrid control system.
After the auxiliary battery is removed and reinstalled, open and close the driver door, and be sure to wait 10 seconds or more before the next hybrid control system start. The hybrid control system may not start immediately after the auxiliary battery is reinstalled.