SHIFT LEVER POSITION SENSOR > ADJUSTMENT |
| 1. INSPECT SHIFT LEVER POSITION SENSOR POSITION |
Apply the parking brake.
Lock the wheels with chocks to secure the vehicle.
Turn the power switch on (READY).
Move the shift lever to D and release the brake.
![]() |
Slowly move the shift lever to N and measure moving distance (A) of the shift lever from the original point to the gear disengagement point.
| *a | Gear Disengagement Point |
| *b | N Position |
| *c | R Position |
| *d | D Position |
Move the shift lever to R and release the brake.
Slowly move the shift lever to N and measure moving distance (B) of the shift lever from the original point to the vehicle disengagement point.
Check that moving distances (A) and (B) shown in the illustration are almost the same.
| 2. ADJUST SHIFT LEVER POSITION SENSOR POSITION |
If moving distance (A) is shorter than (B). [*1]
Move the shift lever to N.
![]() |
Loosen the 2 bolts.
![]() |
Slightly turn the shift lever position sensor counterclockwise.
![]() |
Tighten the 2 bolts in the order shown in the illustration.
Recheck the shift lever position sensor.
If moving distance (B) is shorter than (A). [*2]
Move the shift lever to N.
![]() |
Loosen the 2 bolts.
![]() |
Slightly turn the shift lever position sensor clockwise.
![]() |
Tighten the 2 bolts in the order shown in the illustration.
Recheck the shift lever position sensor.