Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › SHIFT LEVER POSITION SENSOR

SHIFT LEVER POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT SHIFT LEVER POSITION SENSOR


    C321302E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Shift Lever Position
    Specified Condition
    7 (+B) - 1 (DB1)
    D or B
    Below 1 Ω
    Except D or B
    10 kΩ or higher
    7 (+B) - 2 (N)
    N
    Below 1 Ω
    Except N
    10 kΩ or higher
    7 (+B) - 3 (PR)
    P or R
    Below 1 Ω
    Except P or R
    10 kΩ or higher
    7 (+B) - 4 (PNB)
    P, N or B
    Below 1 Ω
    Except P, N or B
    10 kΩ or higher
    7 (+B) - 6 (DB2)
    D or B
    Below 1 Ω
    Except D or B
    10 kΩ or higher
    7 (+B) - 8 (P)
    P
    Below 1 Ω
    Except P
    10 kΩ or higher
    7 (+B) - 9 (R)
    R
    Below 1 Ω
    Except R
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Lever Position Sensor)
    If the result is not as specified, replace the shift lever position sensor.