Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › CANISTER

CANISTER > INSPECTION

for Preparation Click here



1. CHECK CHARCOAL CANISTER


  1. Inspect the ventilation of the canister.



      A267648E01
    1. Apply compressed air into port A and check that air flows out from port B.
      Text in Illustration 
      *a
      Air
      If a problem is found, replace the fuel pump sub-assembly.



  1. Inspect the check valve.



      A267649E01
    1. Close port A and apply compressed air into port B.
      Text in Illustration 
      *a
      Air

      OK:
      Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches the specified level.



    2. A267650E01
    3. Close port A. Using a hand-held vacuum pump, apply a vacuum to port B.

      OK:
      The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches the specified level.