STEERING ANGLE SENSOR > INSTALLATION |
| 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Install the spiral cable with sensor sub-assembly .
| 2. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Engage the 2 claws to install the upper steering column cover.
| 3. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Engage the 4 claws to install the lower steering column cover.
![]() |
Install the 3 screws.
| 4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD |
| 5. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Rotate the spiral cable with sensor sub-assembly counterclockwise slowly by hand until it stops.
![]() |
Rotate the spiral cable with sensor sub-assembly clockwise approximately 2.5 turns to align the marks.
| *a | Alignment Mark |
| 6. INSTALL STEERING WHEEL ASSEMBLY |