DTC B278A Short to GND in Immobiliser System Power Source Circuit |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B278A | A short to GND in the power supply of the transponder key amplifier of the power switch (VC5 - VC5) (1 trip detection logic*). |
| With the shift lever in P, the key held near the power switch and a hybrid control system start operation is performed by pressing and holding the power switch when the key battery is depleted. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Hybrid control system cannot be started when key battery is depleted by holding key near power switch and pressing and holding power switch with shift lever in P | - |
| DTC Code | Data List and Active Test |
| B278A | - |

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - POWER SWITCH) |
Disconnect the G55 and G54 certification ECU (smart key ECU assembly) connectors.
Disconnect the G48 power switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G54-9 (VC5) - G48-10 (VC5) | Always | Below 1 Ω |
| G55-6 (AGND) - G48-6 (AGND) | Always | Below 1 Ω |
| G48-10 (VC5) - Body ground | Always | 10 kΩ or higher |
| G48-6 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reconnect the G55 and G54 certification ECU (smart key ECU assembly) connectors.
Reconnect the G48 power switch connector.
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | G48-10 (VC5) - G48-6 (AGND) |
| Tool Setting | 2 V/DIV., 200 ms./DIV. |
| Condition | Power switch off, key not in cabin, within 30 seconds after power switch pressed |
| *a | Component with harness connected (Power Switch) |
|
| ||||
| OK | ||
| ||