Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR ABSORBER CAP


    C249967
  1. Disengage the 2 claws and 2 guides, and remove the rear absorber cap.



3. REMOVE REAR SHOCK ABSORBER ASSEMBLY


    C249973E01
  1. Support the spring seat of the rear axle beam assembly using a jack and wooden block.
    Text in Illustration 
    *1
    Wooden Block
    *2
    Jack

    CAUTION:
    Do not jack up the rear axle beam assembly too high as the vehicle may fall.

    NOTICE:
    Keep supporting the rear axle beam assembly with a jack until the installation of the rear shock absorber assembly is complete.



    C249537
  1. Remove the 2 nuts while keeping the piston rod from rotating.

  1. Remove the rear shock absorber cushion retainer and rear suspension support.



    C106031E01
  1. Remove the bolt while holding the nut and remove the rear shock absorber assembly.
    Text in Illustration 
    *1
    Wooden Block
    *2
    Jack

    NOTICE:
    Since a stopper nut is used, turn the bolt.



4. REMOVE REAR SUSPENSION SUPPORT STOPPER


5. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY