Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
  1. Secure the steering column assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a drill, drill a hole in the steering lock set bolt, to insert a screw extractor.



    C232526
  1. Using the screw extractor, remove the steering lock set bolt and remove the steering lock actuator assembly.



2. REMOVE POWER STEERING MOTOR ASSEMBLY (for LHD)

NOTICE:
  1. Do not drop the power steering motor assembly, strike it with tools or subject it to impacts.
  2. If the power steering motor assembly is subjected to an impact, replace it with a new one.
  3. Do not pull the wire harness and tilt steering support bond cable of the power steering motor assembly.
  4. Do not allow any moisture to come into contact with the power steering motor assembly.
  5. Do not loosen any bolts not mentioned in the procedure.
  6. Do not allow any foreign objects to contaminate the power steering motor assembly.



    C243853
  1. Cut the clamp, and remove the clamp and the 3 pieces of tape from the wire harness.

    NOTICE:
    When removing the clamp and the tape, be careful not to damage the wire harness.



    C241870
  1. Remove the 2 bolts and power steering motor assembly from the electric power steering column sub-assembly.



3. REMOVE POWER STEERING MOTOR ASSEMBLY (for RHD)

NOTICE:
  1. Do not drop the power steering motor assembly, strike it with tools or subject it to impacts.
  2. If the power steering motor assembly is subjected to an impact, replace it with a new one.
  3. Do not pull the wire harness and tilt steering support bond cable of the power steering motor assembly.
  4. Do not allow any moisture to come into contact with the power steering motor assembly.
  5. Do not loosen any bolts not mentioned in the procedure.
  6. Do not allow any foreign objects to contaminate the power steering motor assembly.

  1. Cut the No. 1 clamp, and remove the No. 1 clamp from the electric power steering column sub-assembly.



    C234654
  1. Disengage the claw and remove the No. 1 steering column protector.



    C234655
  1. Disengage the No. 2 clamp from the No. 1 steering column protector.

  1. Cut the No. 2 clamp and No. 3 clamp, and remove the clamps and the 2 pieces of tape from the wire harness.

    NOTICE:
    When removing the clamp and the tape, be careful not to damage the wire harness.



    C234656
  1. Remove the 2 bolts and power steering motor assembly from the electric power steering column sub-assembly.