STEERING PAD > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH |
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Disengage the claw and guide to remove the lower No. 3 steering wheel cover.
| 5. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Disengage the claw and guide to remove the lower No. 2 steering wheel cover.
| 6. REMOVE HORN BUTTON ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Using a "TORX" driver, push in the 2 torsion springs to disengage the 2 pins.
| *1 | Torsion Spring |
Pull out the horn button assembly from the steering wheel assembly and support the horn button assembly with one hand.
![]() |
Disconnect the horn connector from the horn button assembly.
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Horn Connector |
| *4 | Airbag Connector Lock |
Disconnect the airbag connector to remove the horn button assembly.