SIDE AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Correct | *b | Incorrect |
Insert the pin (stopper) into the body hole and install the side airbag sensor assembly to the vehicle body with the bolt.

| *1 | White Housing Lock | - | - |
| *a | Slide | - | - |
Connect the connector to the side airbag sensor assembly.
Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).
Check that there is no looseness in the installation parts of the side airbag sensor assembly.
| 2. INSTALL CENTER PILLAR LOWER GARNISH |
Engage the 4 claws and 2 clips to install the center pillar lower garnish LH.
| 3. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
| 4. INSTALL REAR DOOR SCUFF PLATE |
Engage the guide and the 5 claws to install the rear door scuff plate.
| 5. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 6. INSTALL FRONT DOOR SCUFF PLATE |
Engage the 8 claws to install the front door scuff plate.
| 7. INSTALL FRONT FLOOR COVER LH (for LH Side) |
| 8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 9. INSTALL FRONT FLOOR COVER RH |
| 10. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 11. INSPECT SRS WARNING LIGHT |