REAR AIRBAG SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE REAR SEAT HEADREST ASSEMBLY |
| 3. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY (for LH Side) |
| 4. REMOVE FRONT FLOOR COVER RH |
| 5. REMOVE FRONT FLOOR COVER LH |
| 6. REMOVE FRONT CENTER FLOOR COVER |
| 7. REMOVE REAR SEAT CUSHION ASSEMBLY |
| 8. REMOVE REAR SEATBACK ASSEMBLY |
| 9. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 10. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 5 claws and guide and remove the rear door scuff plate LH.
| 11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
| 12. REMOVE DECK BOARD ASSEMBLY |
Remove the deck board assembly.
| 13. REMOVE DECK FLOOR BOX LH |
Remove the deck floor box LH.
| 14. REMOVE DECK FLOOR BOX RH |
| 15. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY |
Remove the package tray trim panel assembly.
| 16. REMOVE REAR DECK TRIM COVER |
![]() |
Remove the 2 clips.
Disengage the 4 claws and 2 guides, and remove the rear deck trim cover.
| 17. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY |
Remove the bolt.
![]() |
Disengage the 2 claws and disconnect the floor anchor of the rear seat 3 point type outer belt assembly.
| 18. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
| *a | Protective Tape |
![]() |
Remove the No. 1 luggage compartment light assembly as shown in the illustration.
Disconnect the connector and remove the No. 1 luggage compartment light assembly.
| 19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY |
Turn the rear seatback hinge in the direction indicated by the arrow shown in the illustration.

| *1 | Rear Seatback Hinge | - | - |
Remove the bolt and 2 screws.
Disengage the 4 claws, 4 clips and guide, and remove the deck trim side panel assembly LH.
| 20. REMOVE SIDE NO. 2 AIRBAG SENSOR ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Disconnect the connector from the side No. 2 airbag sensor assembly.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Connector Lock is Released | - | - |
Push down the white housing lock again and disconnect the connector.
![]() |
Remove the bolt and side No. 2 airbag sensor assembly from the vehicle body.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Incorrect | *b | Correct |