Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY

KNEE AIRBAG ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the lower No. 1 instrument panel airbag assembly.



1. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the lower No. 1 instrument panel airbag assembly installed on the vehicle.

    HINT:
    The defects are as follows:
    1. Cuts
    2. Small cracks
    3. Significant discoloration

    OK:
    No defects are found.

    If any of the defects is found, replace the lower No. 1 instrument panel airbag assembly with a new one.



2. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the lower No. 1 instrument panel airbag assembly removed from the vehicle.

    HINT:
    The defects are as follows:
    1. Cuts
    2. Small cracks
    3. Significant discoloration
    4. Cracks or other damage to the connector
    5. Deformation or cracks on the lower instrument panel assembly or instrument panel reinforcement assembly

    OK:
    No defects are found.

    If any of the defects is found, replace the lower No. 1 instrument panel airbag assembly, lower instrument panel sub-assembly or instrument panel reinforcement assembly with a new one.