Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 INSTRUMENT PANEL WIRE


    B300251E01
  1. Connect the airbag connector of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
    Text in Illustration 
    *1
    Airbag Connector
    *2
    Airbag Connector Lock

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the airbag connector lock to install the airbag connector to the instrument panel passenger airbag assembly.

  1. Connect the No. 2 instrument panel wire to the instrument panel passenger airbag assembly clamp.



2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
  1. Engage the 3 hooks.

  1. Push the instrument panel passenger airbag assembly to engage the 3 hooks.

  1. Install the 2 screws to install the instrument panel passenger airbag assembly.

  1. Engage the clamp to the upper instrument panel assembly.



3. INSTALL NO. 2 HEATER TO REGISTER DUCT ASSEMBLY


    B301696
  1. Install the No. 2 heater to register duct assembly with the 3 screws <B>.



4. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY


  1. When using a new instrument panel sub-assembly:



    1. Immediately before installing the upper instrument panel assembly, twist and cut off the portion shown in the illustration.


      B301706



  1. Push the upper instrument panel assembly in the direction indicated by the arrow (1) to engage the 5 guides.


    B301693E01

  1. Push the upper instrument panel assembly in the direction indicated by the arrow (2) to engage the 7 clips to install the upper instrument panel assembly.

  1. Install the bolt <A>.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Install the screw <C>.

  1. Install the 2 clips.

  1. w/ Navigation System:

    1. Connect the connector.



5. CONNECT NO. 2 INSTRUMENT PANEL WIRE
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B300246
  1. Connect the connector.

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.



6. INSTALL FRONT PILLAR GARNISH RH



7. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)