Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE FRONT PILLAR GARNISH RH
(Click here)


3. DISCONNECT NO. 2 INSTRUMENT PANEL WIRE
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B300245E01
  1. Slide the slider to release the lock, and then disconnect the connector.
    Text in Illustration 
    *a
    Slider

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



4. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY


  1. Remove the bolt <A>.


    B301690E01


    Text in Illustration 
    *1
    Bolt <A>
    *2
    Screw <C>

  1. Remove the screw <C>.

  1. Using a clip remover, remove the 2 clips.



  1. Pull the upper instrument panel assembly in the direction indicated by the arrow (1) to disengage the 7 clips.


    B301692E01

  1. Pull the upper instrument panel assembly in the direction indicated by the arrow (2) to disengage the 5 guides and remove the upper instrument panel assembly.



5. REMOVE NO. 2 HEATER TO REGISTER DUCT ASSEMBLY


    B301696
  1. Remove the 3 screws <B> and No. 2 heater to register duct assembly.



6. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:
When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.



    B300247
  1. Remove the 2 screws.

  1. Disengage the clamp from the upper instrument panel assembly.



    B300248
  1. Lean the upper instrument panel assembly and disengage the 3 hooks.



    B300249
  1. Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the upper instrument panel assembly.



7. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    B300250E01
  1. Separate the No. 2 instrument panel wire from the instrument panel passenger airbag assembly clamp.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Airbag Connector
    *3
    Airbag Connector Lock

  1. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.

  1. Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.