REAR AXLE HUB BOLT > REPLACEMENT |
| 1. PRECAUTION |
| 2. DISABLE BRAKE CONTROL |
Wait at least 2 minutes after turning the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 3. REMOVE REAR WHEEL |
| 4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
![]() |
Release the parking brake and remove the rear brake drum.
![]() | Contract |
Remove the shoe adjusting hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
| 5. REMOVE REAR AXLE HUB BOLT |
![]() |
Temporarily install 2 service nuts to the rear axle hub bolts as shown in the illustration.
| *1 | Service Nut |
Using SST and a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.
| 6. INSTALL REAR AXLE HUB BOLT |
![]() |
Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.
| *1 | Service Nut |
| *2 | Washer |
Install a washer and service nut to the new rear axle hub bolt as shown in the illustration.
Using a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the service nut.
Remove the 3 service nuts and washer from the 3 rear axle hub bolts.
| 7. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY |
Install the rear brake drum.
| 8. INSTALL REAR WHEEL |
| 9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
Connect the cable to the negative (-) auxiliary battery terminal .
Connect the reservoir level switch connector.
Clear the DTCs (Click here).