Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      11.6 to 12.4 Ω

      If the result is not as specified, replace the fuel injector assembly.



  1. Inspect the injector injection volume.

    CAUTION:
    Keep the injector away from sparks during the test.




      A264971E01
    1. Connect SST (fuel tube connector) to SST (hose) with SST (hose band), and then connect them to the fuel pipe (vehicle side).
      Text in Illustration 
      *1
      SST
      (Hose)
      *2
      SST
      (Hose Band)
      *3
      SST
      (Fuel Tube Connector)
      *4
      Fuel Pipe (Vehicle Side)

      SST
      09268-31014   (09268-41500, 09268-41700, 95336-08070)

    2. Install a new O-ring to the fuel injector.



    3. A264972E01
    4. Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).
      Text in Illustration 
      *1
      SST
      (Hose)
      *2
      SST
      (Hose Band)
      *3
      SST
      (Adapter)
      *4
      O-ring
      *5
      SST
      (Clamp)
      *6
      Vinyl Tube

      SST
      09268-31014   (09268-41110, 09268-41300, 09268-41700, 95336-08070)

    5. Install a vinyl tube onto the injector.

      CAUTION:
      Install a suitable vinyl tube onto the injector to contain any gasoline spray.



    6. A264974E01
    7. Tie the clamp and adapter together with a tie band as shown in the illustration.
      Text in Illustration 
      *1
      SST
      (Tie Band)
      *2
      SST
      (Adapter)
      *3
      SST
      (Clamp)

      SST
      09268-31014   (09268-41110, 09268-41300, 09268-41800)

    8. Put the injector into a graduated cylinder.

    9. Operate the fuel pump .



    10. A264973E01
    11. Connect SST (wire) to the injector and the auxiliary battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
      Text in Illustration 
      *1
      SST
      (Wire)
      *a
      Connect

      SST
      09842-30080  

      NOTICE:
      Always switch the voltage on and off at the auxiliary battery side, not the injector side.

      Standard Injection Volume:
      Tester Connection
      Condition
      Specified Condition
      Positive terminal - Ground terminal
      Per 15 seconds
      47 to 58 cc (2.9 to 3.5 cu.in.)

      Difference between each injector:
      11 cc (0.6 cu.in.) or less

      If the result is not as specified, replace the fuel injector assembly.

  1. Inspect for leaks.

    1. In the condition above, disconnect the tester probes of SST (wire) from the auxiliary battery and check for fuel drop from the injector.

      Standard fuel drop:
      1 drop or less per 12 minutes

      If fuel drop is not as specified, replace the fuel injector assembly.