Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT LEVELING SWITCH


  1. Voltage Check

    1. Connect a positive (+) lead from the auxiliary battery to terminal 1 (B) and a negative (-) lead to terminal 4 (E).



    2. E190203E03
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Position
      Specified Condition
      2 (T) - 4 (E)
      0
      8.7 to 13.0 V
      1
      7.6 to 11.5 V
      2
      6.6 to 10.0 V
      3
      5.5 to 8.5 V
      4
      4.4 to 7.0 V
      5
      3.4 to 5.6 V

      HINT:
      Auxiliary battery voltage is 12 V.

      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)
      If the result is not as specified, replace the headlight leveling switch.



  1. Illumination Inspection



      E190203E02
    1. Apply auxiliary battery voltage to the headlight leveling switch and check that the switch illuminates.

      OK:
      Tester Connection
      Specified Condition
      Auxiliary battery positive (+) → Terminal 3 (ILL+)
      Auxiliary battery negative (-) → Terminal 4 (E)
      Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)
      If the result is not as specified, replace the headlight leveling switch.