Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA
  1. Whenever a meter DTC is detected, the meter ECU stores the current vehicle state as Freeze Frame Data.


CHECK FREEZE FRAME DATA
  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Combination Meter / DTC.

  5. According to the intelligent tester display, select the trouble code data display with Freeze Frame Data.

  6. Read the Freeze Frame Data recorded when the DTC was set.

    Combination Meter 
    Tester Display
    Condition
    Displayed Item
    B1503
    Exhaust Heat Management Warning Detected
    Trip
    Elapsed time after turning the power switch on (READY)
    B1504
    Lost Communication with Steering SW
    Trip
    Elapsed time after turning the power switch on (READY)
    B1507
    Open in turn signal circuit
    Trip
    Elapsed time after turning the power switch on (READY)
    B1508
    Short in turn signal/hazard flasher circuit
    Trip
    Elapsed time after turning the power switch on (READY)
    U0100
    Lost Communication with ECM/PCM "A"
    1. TRIP
    2. Elapsed time after power switch on (READY)
    U0129
    Lost Communication with Brake System Control Module
    1. TRIP
    2. Elapsed time after power switch on (READY)
    U0131
    Lost Communication with Power Steering Control
    1. TRIP
    2. Elapsed time after power switch on (READY)
    U0142
    Lost Communication with Body Control Module "B"
    1. TRIP
    2. Elapsed time after power switch on (READY)
    U0151
    Lost Communication with Restraints Control Module
    1. TRIP
    2. Elapsed time after power switch on (READY)


CLEAR FREEZE FRAME DATA

NOTICE:
Clearing the DTCs will also clear the Freeze Frame Data.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Clear DTCs and Freeze Frame Data (Click here).