Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P1606-308    Collision has been detected or Collision Sensor Connection (Open)

DTC    P1606-317    Collision has been detected or Collision Sensor Connection (Open)

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU receives a signal that indicates a collision from the airbag sensor assembly to detect a collision. After detecting a collision, the hybrid vehicle control ECU shuts off the high voltage systems for safety.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P1606
308
Shutoff signal from the airbag sensor assembly is determined.
  1. Airbag sensor assembly
  2. Hybrid vehicle control ECU
  3. Supplemental restraint systems
317
A collision is determined due to a wiring malfunction.
  1. Hybrid vehicle control ECU
  2. Supplemental restraint systems

HINT:
If P1606-308 or 317 is output, the vehicle cannot start unless the DTCs are cleared using the intelligent tester.


INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Turn the power switch on (IG) and wait for 5 seconds or more.

1.CHECK VEHICLE FOR COLLISION DAMAGE
  1. Check the vehicle condition.

    Result:
    Result
    Proceed to
    The vehicle is not damaged.
    A
    The vehicle is damaged.
    B



B
REPAIR VEHICLE
A


2.CHECK DTC OUTPUT (HYBRID CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P1606 only is output.
    A
    P0A1D is output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (P0A1D) (Click here)
A


3.CHECK AIRBAG SYSTEM
  1. Troubleshoot the airbag system (Click here).

    Result:
    Result
    Proceed to
    The system is normal.
    A
    There is a malfunction in the system.
    B



B
REPAIR MALFUNCTIONING PARTS, COMPONENT AND AREA
A


4.CHECK INFORMATION CODE
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Access the freeze frame data of DTC P1606 and read the INF code.

    Result:
    Result
    Proceed to
    INF code 308 is output.
    A
    INF code 317 is output.
    B

  1. Turn the power switch off.



B
Go to step 5
A

REPLACE AIRBAG SENSOR ASSEMBLY (Click here)  

5.CHECK DTC OUTPUT (HYBRID CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    One or two of the following conditions are met.
    A
    All of the following conditions are met.
    B

    DTC Output Status
    DTC P3107-213 or P3107-214 is output.
    DTC U0151-763 is output.
    DTC U0110-194, 197, 199, 230 or U0110-657 is output.

  1. Turn the power switch off.



B
GO TO DTC CHART (HYBRID CONTROL SYSTEM) (Click here)
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)