Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY
  1. Check that the float moves smoothly between F and E.



    A267870E01
  1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below. (Type A)
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)

    Standard Resistance:
    Tester Connection
    Float Level
    Specified Condition
    1 - 2
    F
    12.0 to 18.0 Ω
    Between F and E
    12.0 to 415.0 Ω (Gradually changes)
    E
    405.0 to 415.0 Ω

    If the value is not as specified, replace the fuel sender gauge assembly.



    A307401E01
  1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below. (Type B)
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)

    Standard Resistance:
    Tester Connection
    Float Level
    Specified Condition
    1 - 2
    F
    13.5 to 16.5 Ω
    Between F and E
    13.5 to 414.5 Ω (Gradually changes)
    E
    405.5 to 414.5 Ω

    If the value is not as specified, replace the fuel sender gauge assembly.