Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0C30-390    Hybrid Battery Pack State of Charge High

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0C30
390
Charge control error
Hybrid vehicle control ECU

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. When the vehicle is stopped with the power switch on (READY) and the shift lever in D, depress the accelerator pedal. The engine rpm will increase as well as "State of Charge (All Bat)".
    If charge current drops, release the accelerator pedal and then depress it again to maintain charging.
  2. Check that charging stops when "State of Charge (All Bat)" reaches the upper limit.

1.CHECK DTC OUTPUT (HYBRID CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P0C30-390 only is output.
    A
    DTCs other than P0C30-390 are output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (HYBRID CONTROL SYSTEM) (Click here)
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)