HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL |
| 1. REMOVE FRONT WHEEL LH (for LHD) |
| 2. REMOVE FRONT FENDER LINER LH (for LHD) |
| 3. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD) |
![]() |
Disengage the 8 claws and remove the front door scuff plate LH.
| 4. REMOVE COWL SIDE TRIM BOARD LH (for LHD) |
![]() |
Remove the clip.
Disengage the clip and remove the cowl side trim board LH.
| 5. REMOVE FRONT WHEEL RH (for RHD) |
| 6. REMOVE FRONT FENDER LINER RH (for RHD) |
![]() |
Remove the 4 screws.
![]() |
Remove the 5 grommets.
![]() |
Remove the 7 clips and front fender liner RH.
| 7. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD) |
| 8. REMOVE COWL SIDE TRIM BOARD RH (for RHD) |
| 9. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the 3 claws and disconnect the hood lock control lever sub-assembly.
Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
| 10. REMOVE HOOD LOCK ASSEMBLY |
![]() |
Remove the 3 bolts.
![]() |
Disconnect the hood lock control cable and remove the hood lock assembly.
| 11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) |
Using a screwdriver, disengage the hood lock control cable assembly from the 3 clamps and hood cable grommet as shown in the illustration.

| *1 | Hood Lock Control Cable | *2 | Clamp |
| *3 | Hood Cable Grommet | - | - |
Pull the hood lock control cable assembly from the engine compartment and remove it.
| 12. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD) |
Using a screwdriver, disengage the hood lock control cable assembly from the 3 clamps and grommet as shown in the illustration.

| *1 | Hood Lock Control Cable | *2 | Clamp |
| *3 | Hood Cable Grommet | - | - |
Pull the hood lock control cable assembly from the engine compartment and remove it.