DTC P0A60-288 Drive Motor "A" Phase V Current |
DTC P0A60-290 Drive Motor "A" Phase V Current |
DTC P0A60-294 Drive Motor "A" Phase V Current |
DTC P0A60-501 Drive Motor "A" Phase V Current |
DTC P0A63-296 Drive Motor "A" Phase W Current |
DTC P0A63-298 Drive Motor "A" Phase W Current |
DTC P0A63-302 Drive Motor "A" Phase W Current |
DTC P0A63-502 Drive Motor "A" Phase W Current |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A60 | 288 | Malfunction in motor inverter current sensor (phase V sub sensor) | Inverter with converter assembly |
| 290 | Malfunction in motor inverter current sensor (phase V main sensor) | ||
| 294 | Malfunction in motor inverter current sensor (performance problem or open phase V) | ||
| 501 | Malfunction in motor inverter current sensor (phase V main and sub sensors offset) | ||
| P0A63 | 296 | Malfunction in motor inverter current sensor (phase W sub sensor) | |
| 298 | Malfunction in motor inverter current sensor (phase W main sensor) | ||
| 302 | Malfunction in motor inverter current sensor (performance problem or open phase W) | ||
| 502 | Malfunction in motor inverter current sensor (phase W main and sub sensors offset) |
| 1.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
| Only P0A60 or P0A63 is output, or DTCs other than the ones in the table below are also output. | A |
| P0A78-202 is output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR) |
Check that the service plug grip is not installed.
![]() |
Check the connector connections and contact pressure of the low voltage connectors of the inverter with converter assembly (Click here).
|
| ||||
| OK | ||
| ||