DTC P0A78-282 Drive Motor "A" Inverter Performance |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A78 | 282 | Motor inverter overvoltage signal detection (circuit malfunction) | Inverter with converter assembly |
| 1.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
| P0A78-282 is set before any of the DTCs in the table below are set. | A |
| Any of the DTCs in the table below are set before P0A78-282 is set. | B |
| DTC No. | Relevant Diagnosis |
| P3000-388, 389, 603 | HV Battery Malfunction |
| P3004-131, 133 | High Voltage Power Resource |
Turn the power switch off.
|
| ||||
| A | |
| 2.CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR) |
Check that the service plug grip is not installed.
![]() |
Check the connector connections and contact pressure of the low voltage connectors of the inverter with converter assembly (Click here).
|
| ||||
| OK | ||
| ||