Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P3147-240    Transmission system

DTC    P3147-242    Transmission system

for Preparation Click here


DESCRIPTION

Refer to the description for DTC P3147-239 .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3147
240
MG1 locked
Hybrid vehicle transaxle assembly
242
Planetary gear locked

INSPECTION PROCEDURE

HINT:
  1. If DTC P3147-240 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
    1. After DTC P3147-241 has been output, drive the vehicle at approximately 15 km/h (9 mph) or more for approximately 10 seconds or more while maintaining a stable vehicle speed.
      (If generator (MG1) does not rotate in this condition, DTC P3147-240 will be stored.)
  2. If DTC P3147-242 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
    1. When the vehicle is stopped, turn the power switch on (READY) and gradually depress the accelerator pedal so that the engine starts.
    2. Drive the vehicle at approximately 20km/h (12 mph) or more for approximately 10 seconds or more while maintaining the vehicle speed.

1.CHECK DTC OUTPUT (HYBRID CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P3147-240 or P3147-242 only is output.
    A
    P0A1D is also output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (P0A1D) (Click here)
A

REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY (Click here)