Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0E34-590    DC/DC Converter Voltage Sensor "A" High

for Preparation Click here


DESCRIPTION

Refer to the description for DTC P0E32-585 .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0E34
590
Open or short to +B in the boost converter voltage (VL) sensor circuit
Inverter with converter assembly

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Turn the power switch on (IG) and wait for 5 seconds or more.

1.REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS
(Click here)

HINT:
The boost converter voltage (VL) sensor is connected to the MG ECU inside the inverter with converter assembly.


NEXT

COMPLETED