Home › Engine / Hybrid System › 1NZ-FXE COOLING › COOLING FAN ECU

COOLING FAN ECU > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COOLING FAN ECU
  1. Put the vehicle in the following conditions:

    1. The power switch is off.

    2. The coolant temperature is less than 92°C (198°F).

    3. The auxiliary battery voltage is between 11 to 14 V.

    4. The A/C switch is off.

  1. Connect the pickup of a clamp-on ammeter over one of the two wires for the cooling fan motor.

  1. Turn the power switch on (IG) and wait for approximately 10 seconds. Check that the fan stops.

  1. Turn the power switch on (IG). Check that the fan stops with the engine idling.

    HINT:
    1. Make sure that the radiator engine coolant temperature is less than 92°C (198°F).
    1. Turn the A/C switch off.

  1. Check that the fan operates when the A/C switch is turned on.

    Standard Current:
    Item
    Specified Condition
    Cooling fan motor
    12.2 to 15.7 A

    HINT:
    The coolant temperature is less than 92°C (198°F).

  1. Check that the fan operates when the engine coolant temperature sensor connector is disconnected.

    Standard Current:
    Item
    Specified Condition
    Cooling fan motor
    12.2 to 15.7 A

  1. Put the engine in inspection mode (Click here).



    A264604E02
  1. After the engine is warmed up, check that the fan operates as shown in the illustration.

    HINT:
    1. The coolant temperature at which the fan starts operating is approximately 96°C (205°F).
    2. This system can also be checked using the intelligent tester.
    3. Select the following menu items: Powertrain / Engine and ECT / Data List / Coolant Temp.