DTC P1578 Brake System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1578 | The hybrid vehicle control ECU receives a brake system error signal for 0.2 sec. or more while the cruise control is in operation |
|

| 1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Check for the DTC.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK FOR DTCs (DTC P1578) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the ON-OFF switch.
Push the -/SET switch to activate the cruise control.
Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P1578 is output | B |
|
| ||||
| A | ||
| ||
| 3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY |
| NEXT | |
| 4.CHECK FOR DTCs (DTC P1578) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the ON-OFF switch.
Push the -/SET switch to activate the cruise control.
Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P1578 is output | B |
|
| ||||
| A | ||
| ||