LIGHTING SYSTEM > Front Door Courtesy Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Door Courtesy | Front door courtesy light switch RH signal/OPEN or CLOSE | OPEN: Front door RH open CLOSE: Front door RH closed | - |
| FL Door Courtesy | Front door courtesy light switch LH signal/OPEN or CLOSE | OPEN: Front door LH open CLOSE: Front door LH closed | - |
| Result | Proceed to |
| OK | A |
| Front door courtesy light switch LH or RH does not operate | B |
|
| ||||
| A | ||
| ||
| 2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (LH OR RH) |
Remove the front door courtesy light switch assembly (Click here).
Inspect the front door courtesy light switch assembly (Click here).
| Result | Proceed to |
| OK (for Front LH) | A |
| OK (for Front RH) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M1-1 - 3D-36 | Always | Below 1 Ω |
| M1-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
| Tester Connection | Condition | Specified Condition |
| 3D-36 - MB-2 (FLCY) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Disconnect the G59 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M2-1 - G59-19 (FRCY) | Always | Below 1 Ω |
| M2-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||