Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Rear Fog Light Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) controls the rear fog light via the RR FOG relay in the instrument panel junction block assembly.

WIRING DIAGRAM


E241400E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.CHECK OPERATION (TAILLIGHTS)
  1. Check the operation of the taillights.

    OK:
    Taillights operate normally.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK


2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. Check that the relay operates.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Rear Fog Light Relay
    Rear fog light relay
    ON/OFF
    Light control switch is in tail position

    OK:
    Rear fog light relay operates. (Rear fog light comes on.)



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly (Click here).



  1. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.


    E241401E01


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    -
    -

  1. Connect a positive (+) lead from the auxiliary battery to terminal 3E-1.

  1. Connect a negative (-) lead from the auxiliary battery to terminal MB-14 (TRLY) and MB-27 (RFGO).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    3D-3 - Body ground
    Always
    11 to 14 V



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (REAR FOG LIGHT - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND BODY GROUND)
  1. Disconnect the M5 rear combination light assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M5-6 (B) - 3D-3
    Always
    Below 1 Ω
    3D-3 - Body ground
    Always
    10 kΩ or higher
    M5-1 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)