Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the power switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the power switch on (IG).

  5. Turn the intelligent tester on.

  6. Enter the following menus:

    1. for Combination Meter: Body / Combination Meter / Data List.

    2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.

    3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

  7. Check the values by referring to the table below.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Tail Relay SW
    Tail relay/OFF or ON
    OFF: Tail relay off
    -
    ON: Tail relay on
    ODO/TRIP Change SW
    ODO/TRIP change switch/OFF or ON
    OFF: Switch released
    -
    ON: Switch pushed
    P-Seatbelt Buckle SW
    Front passenger seat belt buckle switch/OFF or ON
    OFF: Front passenger seat belt fastened (warning light off)
    -
    ON: Front passenger seat belt unfastened (warning light on)
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost the same as actual vehicle speed
    -
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12750 rpm
    900 to 1050 rpm: Idling
    -
    Coolant Temperature
    Engine coolant temperature/-40 to 127.5°C (-40 to 261.5°F)
    After warming up: 75 to 100°C (167 to 212°F)
    1. After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).
    2. After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
    Light Control Switch
    Light control switch/OFF or ON
    OFF: Light control switch off
    -
    ON: Light control switch not off
    Multi Display Select Switch
    DISP switch in the steering pad switch assembly/OFF or ON
    OFF: DISP switch in the steering pad switch assembly not pressed
    -
    ON: DISP switch in the steering pad switch assembly pressed
    +B Voltage Value
    Auxiliary battery voltage/Min.: 0 V, Max.: 25.5 V
    11 to 16 V
    -
    Fuel Input
    Fuel input/Min.: 0, Max. 127.5
    10th segment comes on: 31.7 to 36.0
    Unit: Liter
    9th segment comes on: 28.3 to 31.7
    8th segment comes on: 25.0 to 28.3
    7th segment comes on: 21.6 to 25.0
    6th segment comes on: 18.2 to 21.6
    5th segment comes on: 14.8 to 18.2
    4th segment comes on: 11.5 to 14.8
    3rd segment comes on: 8.1 to 11.5
    2nd segment comes on: 4.7 to 8.1
    1st segment comes on: 3.8 to 4.7
    Ambient Temperature
    Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F)
    Almost the same as actual outside temperature
    The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
    HV System Indicator
    Hybrid system indicator value/ Min.: -512, Max.: 511
    -512 to 511
    -
    Oil Pressure Switch
    Oil pressure switch/OFF or ON
    OFF: Engine started
    -
    ON: Engine not started
    Turn Signal Switch (Right)
    RH turn signal switch/OFF or ON
    OFF: RH turn signal switch off
    -
    ON: RH turn signal switch on
    Turn Signal Switch (Left)
    LH turn signal switch/OFF or ON
    OFF: LH turn signal switch off
    -
    ON: LH turn signal switch on
    Hazard Flasher Switch
    Hazard warning switch/OFF or ON
    OFF: Switch released
    -
    ON: Switch pushed
    Headlight Auto Leveling Switch
    Headlight auto leveling control/OFF or ON
    OFF: Headlight auto level control off
    -
    ON: Headlight auto level control on
    Key Remind Sound
    Cycle of the key reminder warning buzzer
    The cycle of the key reminder warning buzzer/Normal, Slow, Fast
    -
    Driver Side Seatbelt Warning Buzzer
    Condition of the seat belt warning buzzer/OFF or ON
    OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened
    Displays customize setting of seat belt warning buzzer
    ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened
    Number of Trouble Code
    The number of DTCs currently stored/0 to 255
    0
    -

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Vehicle stopped: 0 km/h (0 mph)
    When driving at constant speed: No large fluctuations

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temp
    Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F)
    75 to 100°C (167 to 212°F): After warming up
    1. Stored as Freeze Frame Data
    2. This is the engine coolant temperature.

    HINT:
    1. After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).
    2. After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
    3. If the value is -40°C (-40°F), or 140°C (284°F), the sensor circuit is open or shorted.
    4. Check if the engine overheats when the value indicates 140°C (284°F).

    NOTICE:
    Enter inspection mode (Click here).


ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Combination Meter / Active Test.

  5. Check the operation by referring to the table below.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    0, 40, 80, 120, 160 km/h
    -
    Tacho Meter Operation*2
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm)
    Not applicable
    Fuel Meter Operation
    Fuel receiver gauge
    EMPTY, 1/2, FULL
    -
    Fuel Consumption Meter Operation*2
    Fuel consumption meter
    OFF, MIN., 1/4, 1/2, 3/4, MAX.
    -
    A/T Indicator Operation 1
    Shift indicator (P, R, N, D)
    OFF or ON
    -
    A/T Indicator Operation 2
    Shift indicator (B)
    OFF or ON
    -
    Indicat. Lamp Airbag
    SRS warning light
    OFF or ON
    -
    Indicat. Lamp Doors All Open
    Door indicator light
    OFF or ON
    -
    Driver Side Seat Belt
    Seat belt warning light
    OFF or ON
    -
    Indicat. Lamp ABS
    ABS warning light
    OFF or ON
    -
    Indicat. Lamp Charge
    Charge warning light
    OFF or ON
    -
    Indicat. Lamp Slip
    Slip indicator light
    OFF or ON
    -
    Indicat. Lamp Beam
    High beam indicator light
    OFF or ON
    -
    Indicat. Lamp Tail
    Tail indicator light
    OFF or ON
    -
    Indicat. Lamp Fr FOG
    Front fog indicator light
    OFF or ON
    -
    Indicat. Lamp Rr FOG*1
    Rear fog indicator light
    OFF or ON
    -
    Indicat. Lamp Fuel
    Fuel level warning light
    OFF or ON
    -
    Indicat. Lamp ECB
    Electronically controlled brake system warning light
    OFF or ON
    -
    Indicat. Oil Pressure
    Oil pressure warning light
    OFF or ON
    -
    Indicat. Lamp Cruise
    Cruise control indicator light
    OFF or ON
    -
    Indicat. Lamp Brake
    Brake warning light
    OFF or ON
    -
    Indicat. EPS
    EPS warning light
    OFF or ON
    -
    Master Warning
    Master warning light
    OFF or ON
    -
    Indicat. Ready (HV)
    Ready indicator light
    OFF or ON
    -
    Indicat. EV Mode
    EV indicator light
    OFF or ON
    -
    Indicat. SET
    SET indicator light
    OFF or ON
    -
    Indicat. ECO Mode
    Eco mode indicator light
    OFF or ON
    -
    EV Mode Indicator
    EV drive mode indicator light
    OFF or ON
    -
    Turn Signal (Left) Indicator
    LH turn indicator light
    OFF or ON
    -
    Turn Signal (Right) Indicator
    RH turn indicator light
    OFF or ON
    -
    Water temperature meter operation
    Engine coolant temperature receiver gauge
    Low, Normal, High
    -
    HV System Indicator
    Hybrid system indicator
    MIN, -50, 0, 100, 200, 300, 400, MAX
    -
    Meter Display 1
    Multi-information display
    OFF, 0, 1, 2, 3, 4, 5, 6, All
    -
    Meter Display 2
    All dots in the ODO/TRIP meter
    OFF, 7, 8, 9
    -

    1. *1: w/ Rear Fog Light
    2. *2: Although the item is displayed on the intelligent tester, no warning light or indicator light is operated.