METER / GAUGE SYSTEM > Malfunction in Water Temperature Warning Light |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication DTCs are output (Click here).
| Result | Proceed to |
| CAN communication DTCs are not output. | A |
| CAN communication DTCs are output. | B |
|
| ||||
| A | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| SFI system DTCs are output. | B |
|
| ||||
| A | |
| 3.READ VALUE USING INTELLIGENT TESTER (COOLANT TEMPERATURE, COOLANT TEMP) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus:
for Combination Meter: Body / Combination Meter / Data List.
for Engine: Powertrain / Engine and ECT / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temperature | Engine coolant temperature / 0 to 127.5°C (0 to 261.5°F) | After warming up: 75 to 100°C (167 to 212°F) | - |
| Tester Display | Measurement Item/Range | Normal Condition | Stored as Freeze Frame Data |
| Coolant Temp | Engine coolant temperature/ Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up |
|
| |||
| Result | Proceed to |
| The data list values of the ECUs do not match. | A |
| The data list values of the ECUs match. | B |
|
| ||||
| A | |
| 4.REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly with a new or a known good one (Click here).
|
| ||||
| OK | ||
| ||