Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P3000-603    Battery Control System

for Preparation Click here


DESCRIPTION

The power management control ECU monitors its internal operation and detects the following malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3000
603
The power management control ECU detects a HV battery cooling system error signal.
  1. Power management control ECU
  2. HV battery

INSPECTION PROCEDURE

CAUTION:
When disposing of an HV battery, make sure to return it through an authorized collection agent who is capable of handling it safely. If the HV battery is returned via the manufacturer specified route, it will be returned properly and in a safe manner by an authorized collection agent.

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Spd", "Temp of Batt TB1 to TB3", "Inhaling Air Temp", "Ambient Temperature" and "Power Resource IB".

1.CHECK DTC OUTPUT (HYBRID CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P3000-603 only is output.
    A
    DTCs other than P3000-603 are also output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (HYBRID CONTROL SYSTEM) (Click here)
A


2.REPLACE POWER MANAGEMENT CONTROL ECU
(Click here)

NEXT

REPLACE HV BATTERY (Click here)