Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0617-142    Starter Relay Circuit High

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors the ST signal received from the certification ECU (smart key ECU assembly). When an error is detected in the ST signal, this DTC is stored.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0617
142
An ST signal from the hybrid vehicle control ECU is on when the power switch is off.
(2 trip detection logic)
  1. Hybrid vehicle control ECU
  2. Wire harness or connector
  3. Certification ECU (smart key ECU assembly)

WIRING DIAGRAM


A148900E13


INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Turn the power switch off and wait for 30 seconds or more.
  2. Turn the power switch on (READY) and wait for 15 seconds or more.
  3. Turn the power switch off and wait for 30 seconds or more.

1.CHECK CONNECTOR CONNECTION CONDITION (HYBRID VEHICLE CONTROL ECU CONNECTOR)


    A279820E01
  1. Check the connector connections and contact pressure of the relevant terminals for the hybrid vehicle control ECU connectors (Click here).
    Text in Illustration 
    *A
    for LHD
    *B
    for RHD

    OK:
    The connectors are connected securely and there are no contact pressure problems.



NG
CONNECT SECURELY
OK


2.CHECK CONNECTOR CONNECTION CONDITION (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) CONNECTOR)
  1. Check the connector connection condition of the certification ECU (smart key ECU assembly).

    HINT:
    Refer to the Service Bulletin for the installation position.

    OK:
    The connector is connected securely and there are no contact problems.



NG
CONNECT SECURELY
OK


3.CHECK HARNESS AND CONNECTOR (ST2 TERMINAL VOLTAGE)
  1. Turn the power switch off.



    A259789E32
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G80-9 (ST2) - Body ground
    Power switch off
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Hybrid Vehicle Control ECU)



NG
Go to step 4
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)  

4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - HYBRID VEHICLE CONTROL ECU)
  1. Disconnect connector G77 from the certification ECU (smart key ECU assembly) connector.



    A259789E32
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G80-9 (ST2) - Body ground
    Power switch off
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Hybrid Vehicle Control ECU)

  1. Connect the certification ECU (smart key ECU assembly) connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)