Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    175/65R15 84H
    230 (2.3, 33)
    220 (2.2, 32)
    195/50R16 84V
    220 (2.2, 32)
    200 (2.0, 29)
    185/60R15 84H
    220 (2.2, 32)
    220 (2.2, 32)



    C164558
  1. Using a dial indicator, check the runout of the tires.

    Maximum tire runout:
    Vertical:
    1.4 mm (0.0551 in.)
    Lateral:
    2.0 mm (0.0787 in.)



2. ROTATE TIRES


    C143305E04
  1. If the spare tire uses a different type of wheel than the other tires, rotate the tires as shown by (A) in the illustration. If the spare tire has the same type of wheel as the other tires, rotate the tires, including the spare tire, as shown by (B) in the illustration.
    Text in Illustration 
    V100135
    Front



3. INSPECT AND ADJUST WHEEL BALANCE


  1. Inspect and adjust the off-the-car balance.

    1. Steel wheel:

      Maximum imbalance:
      8.0 g (0.0176 lb)



    2. C144018E06
    3. Others (Non-steel wheel):

      Maximum imbalance:
      8.0 g (0.0176 lb)

      NOTICE:
      1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
      2. Do not touch the adhesive surface of the tape.
      3. Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

        Width (A):
        25 mm (0.984 in.)

      4. Push the balance weight securely with your finger to adhere it to the desired position.
      5. Do not reuse balance weights.

      HINT:
      The inner side balance weight should be installed by clipping it to the rim.



4. INSPECT FRONT AXLE HUB BEARING
(Click here)


5. INSPECT REAR AXLE HUB BEARING
(Click here)