BODY > GENERAL MAINTENANCE |
| 1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY |
If necessary, tighten the bolts and nuts on the chassis parts listed below.
If necessary, tighten the bolts and nuts on the body parts listed below.
| 2. REPLACE AIR CONDITIONING FILTER |
Remove the air conditioning filter .
Visually inspect the surface of the air conditioning filter.
If the air conditioning filter is contaminated with foreign matter, replace it.
| 3. ROAD TEST |
Check the engine and chassis for abnormal noises.
Check that the vehicle does not wander or pull to one side.
Check that the brakes work properly and do not drag.
Bed-in the parking brake shoes to the drums.
| 4. BODY INSPECTION |
Check the body exterior for dents, scratches and rust.
Check the underbody for rust and damage.
If necessary, replace the damaged part or repair the damaged area.
| 5. FINAL INSPECTION |
Check the operation of the body parts.
Hood
Front and rear doors
Back door
Seats
Be sure to deliver a clean car. Make sure to check the following: