Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK POWER STEERING ECU ASSEMBLY

C240518E03


Text in Illustration 
*a
Component without harness connected
(Power Steering ECU Assembly)
-
-
  1. Measure the voltage and resistance according to the value(s) in the table below.

    NOTICE:
    1. Check if the power steering ECU assembly connectors are securely connected by pulling on them from the backside.
    2. If the EPS warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU's terminals to become 0 V.


    Terminals No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G6-1 (IG) - Body ground
    L - Body ground
    IG power source
    Power switch on (IG)
    9 to 16 V
    G6-6 (TS) - Body ground
    G - Body ground
    Test mode signal
    Always
    9 to 16 V
    G6-7 (CANH) - G6-8 (CANL)
    LG - W
    CAN communication line
    Power switch off (lock)
    54 to 69 Ω
    z7-1 (TRQ2) - Body ground
    Y - Body ground
    Torque sensor 2 input signal
    Power switch on (ready), steering wheel not being turned (without load)
    2.3 to 2.7 V
    Power switch on (ready), steering wheel being turned to right
    1.2 to 2.5 V
    Power switch on (ready), steering wheel being turned to left
    2.5 to 3.8 V
    z7-2 (TRQG) - Body ground
    B - Body ground
    Torque sensor ground
    Always
    Below 1 Ω
    z7-8 (TRQV) - Body ground
    R - Body ground
    Torque sensor power source
    Power switch on (ready)
    4.5 to 5.5 V
    z7-9 (TRQ1) - Body ground
    W - Body ground
    Torque sensor 1 input signal
    Power switch on (ready), steering wheel not being turned (without load)
    2.3 to 2.7 V
    Power switch on (ready), steering wheel being turned to right
    2.5 to 3.8 V
    Power switch on (ready), steering wheel being turned to left
    1.2 to 2.5 V
    z8-1 (M1) - Body ground
    R - Body ground
    Power steering motor assembly output signal 1
    Power switch on (ready), steering wheel being turned to left
    9 to 16 V
    Power switch on (ready), steering wheel being turned to right
    6 to 8 V
    z8-2 (M2) - Body ground
    B - Body ground
    Power steering motor assembly output signal 2
    Power switch on (ready), steering wheel being turned to left
    6 to 8 V
    Power switch on (ready), steering wheel being turned to right
    9 to 16 V
    A33-1 (PIG) - Body ground
    W - Body ground
    Power steering motor assembly power supply input signal
    Always
    9 to 16 V
    A33-2 (PGND) - Body ground
    W-B - Body ground
    Power ground
    Always
    Below 1 Ω
    If the result is not as specified, the ECU may have a malfunction.