Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING


    C233390E01
  1. Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar.
    Text in Illustration 
    *1
    Stopper Ring
    V100135
    Front of the Vehicle
    V100136
    Outside of the Vehicle

    HINT:
    1. Install the front No. 1 stabilizer bar bushing onto the front stabilizer bar so that the stopper ring of the front stabilizer bar faces the outside of the vehicle.
    2. Install the front No. 1 stabilizer bar bushing with its cutout facing the front of the vehicle.



2. INSTALL FRONT STABILIZER BAR


    C233662E01
  1. Install the front stabilizer bar to the front suspension crossmember sub-assembly so that the identification mark is positioned on the left side of the vehicle.
    Text in Illustration 
    *a
    Identification Mark
    V100135
    Left Side of the Vehicle



3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH


    C249891E01
  1. Install the front No. 1 stabilizer bracket LH to the front suspension crossmember sub-assembly with the 2 bolts.
    Text in Illustration 
    V100136
    Front of the Vehicle

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }

    NOTICE:
    Temporarily tighten the bolt A and then fully tighten the 2 bolts in the order of B and A.



4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



5. INSTALL STEERING LINK ASSEMBLY


    C244486
  1. Install the steering link assembly to the front suspension crossmember sub-assembly with the 2 bolts and 2 nuts.

    Torque:
    79 N*m{ 800 kgf*cm , 58 ft.*lbf }

    NOTICE:
    1. Keep the nut from rotating while turning the bolt because the nut has its own stopper.
    2. Make sure to tighten the bolts starting from the right side of the vehicle.



6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the front stabilizer link assembly to the front shock absorber assembly with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    Use a hexagon socket wrench to hold the stud.



7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



8. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY