Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR

FRONT SPEED SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure is for the LH side.
  3. If the sensor rotor needs to be replaced, replace the front axle hub.



1. INSTALL FRONT SPEED SENSOR
  1. Install the front speed sensor onto the steering knuckle with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Check that the front speed sensor tip and installation portion are free of foreign matter.
    2. Install the front speed sensor without turning it from its original installation angle.

  1. Install the No. 1 clamp onto the shock absorber with the bolt and front flexible hose.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Install the No. 2 clamp onto the body with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Engage the 2 clamps onto the body.

  1. Install the No. 3 clamp onto the body.

  1. Connect the front speed sensor connector.

  1. Engage the clamp onto the body.



2. INSTALL FRONT FENDER LINER

HINT:
Use the same procedure for the LH side and RH side .



3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL



4. CHECK FOR SPEED SENSOR SIGNAL
(Click here)