Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT

BACK DOOR SUPPORT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE BACK DOOR STAY ASSEMBLY

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.



    B297014E03
  1. Using a screwdriver, remove the 2 stop rings as indicated by the arrows, in the order shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.

  1. Release the ball joint and remove the back door stay assembly.

    NOTICE:
    Remove the back door stay assembly while supporting the back door by hand.



2. REMOVE BACK DOOR DAMPER STAY UPPER BRACKET


    B297016
  1. Remove the 2 bolts and back door damper stay upper bracket.



3. REMOVE BACK DOOR STAY BOLT


    B314068
  1. Remove the back door stay bolt.