Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. REMOVE FRONT FLOOR COVER RH


    B301488E01
  1. Using a clip remover, remove the 2 clips <A>.

  1. Disengage the 3 clips <B>.



    B301489
  1. Disengage the 3 guides and remove the front floor cover RH.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE ECM (for RHD)


    A267404
  1. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

    NOTICE:
    After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.



    A267405
  1. Remove the bolt and nut.

  1. Remove the ECM.



    A267867
  1. Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.



5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD)
(Click here).


6. REMOVE INNER COWL TOP TO COWL BRACE (for LHD)


    C250011
  1. Remove the 3 bolts and inner cowl top to cowl brace.



7. REMOVE FRONT AIR SHUTTER SEAL (for LHD)


    C250012
  1. Disengage the clamp to remove the front air shutter seal.



8. REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)


    C250013
  1. Disengage the clamp to remove the front No. 1 ventilator seal.



9. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    C250014
  1. Disengage the clamp to separate the wire harness from the outer cowl top panel sub-assembly.



    C250015
  1. Remove the 8 bolts, nut and outer cowl top panel sub-assembly.



10. REMOVE ECM (for LHD)


    A267430
  1. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

    NOTICE:
    After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.



    A267431
  1. Remove the bolt and nut.

  1. Remove the ECM.



    A267428
  1. Remove the nut.



    A267429
  1. Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.