Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM

VEHICLE PROXIMITY NOTIFICATION SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Turn the power switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the GTS on.

  5. Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Data List.

  6. Read the Data List according to the display on the GTS.

    Vehicle Proximity Notification System 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift Position
    P position switch / Not Parking or Parking
    Not Parking or Parking
    -
    Stop Light SW
    Stop light switch / OFF or ON
    OFF: Brake pedal released
    ON: Brake pedal depressed
    -
    Oil Pressure SW
    Oil pressure switch / OFF or ON
    OFF: Engine started
    ON: Engine not started
    -
    Operation Cancel SW
    Vehicle approaching speaker switch condition / OFF or ON
    OFF: Vehicle approaching speaker switch not pressed
    ON: Vehicle approaching speaker switch pressed
    -
    Vehicle Speed
    Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost the same as actual vehicle speed
    -
    Proximity Sound Volume Adjustment
    Warning sound volume setting / Standard, Standard +1, Standard +2
    Customized value displayed
    -
    Proximity Sound Level Increase (Vehicle Starting)
    Warning sound amplifier function when vehicle starts off / OFF or ON
    Customized value displayed
    -
    Proximity Sound Control (Vehicle Stationary)
    Warning sound setting function when vehicle stopped / OFF or ON
    Customized value displayed
    -
    Number of DTC
    Number of trouble codes / Min.: 0 Max.: 255
    Number of DTCs displayed
    -


ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Turn the power switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the GTS on.

  5. Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Active Test.

  6. Perform the Active Test according to the display on the GTS.

    Vehicle Proximity Notification System 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Proximity Sound Indicator
    Proximity sound indicator
    OFF or ON
    -
    Proximity Sound (Vehicle Stationary)
    Proximity sound (Vehicle stationary)
    OFF or ON
    Produces warning sound when vehicle is stopped
    Proximity Sound (Low Speed)
    Proximity sound (Low speed)
    OFF or ON
    Produces warning sound when vehicle is being driven at speeds of 10 km/h (6 mph)