Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > INSPECTION

for Preparation Click here



1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
  1. Connect 3 dry cell batteries (1.5 V) in series.

    NOTICE:
    Do not use rechargeable batteries as they may not output a voltage of 1.5 V.



  1. Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).


    E151424E02


    Text in Illustration 
    *a
    Component without harness connected
    (Rear Height Control Sensor Sub-assembly)
    *b
    Low
    *c
    Normal
    *d
    High

  1. Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (SHRR) - 1 (SHG)
    +45°(High)
    4.05 V
    2 (SHRR) - 1 (SHG)
    0°(Normal)
    2.25 V
    2 (SHRR) - 1 (SHG)
    -45°(Low)
    0.45 V